This diy project only takes about an h.
How to change a full screen door to glass insert.
Insert the screen panel into the door.
Install the new glass by lifting the door off of the sawhorses and lay the outer frame with glass over the sawhorses.
Slide it into the door channel in front of the screen.
It should not go in between the screen and the door frame.
Remove the glass and place the screen in the door opening.
Larson retainer strips have dash and arrow markings on them or read insert this edge to place strips around the glass position the marked side of the strip toward the door frame and slide it in the channel at the edge of the glass.
Installing the larson retainer strips on the larson door in this case a larson lakeview door.
Insert the retainer strips in place.
It should slide into the frame as neatly as the glass panel did.
To ensure that the glass is correctly installed the temper stamp should appear on the bottom of the door carefully lay the door over the door glass.
Secure the screen panel to the door using the spring clips or screwed brackets.
Jeff from harvey building product takes you through the steps of how to replace the glass in your harvey storm door.
Start at the top of the door and hold the retainer at about a 45 degree angle with the edge with writing on it facing you.