Honda Door Lock Actuator Screws Stuck

Take the inside door release lever panel off and push the lever rod all the way to the rear.

Honda door lock actuator screws stuck.

In some cars the door lock actuator is positioned below the latch. Average repair cost is 610 at 84 500 miles. 2007 honda cr v door lock actuator repair. Just unhook and slide through the holes on the metal.

Unclip and remove the inside door handle rod can t remember if i did this before or after unscrewing the locking mechanism. If you are having problems with your door locks this is the video for you make sure to watch until then. Observe the plastic tab above and beneath this screw. A rod connects the actuator to the latch and another rod connects the latch to the knob that sticks up out of the top of the door.

Unclip the broken actuator from the locking assembly. The lock actuator is behind this screw. Using a screwdriver test that the locking mechanism works by locking the latch then checking if the door latch releases using the outer handle lever. Car door lock actuators are designed to lock and unlock a door without the effort of pulling on a cable and rod.

The latch assembly gets corroded and when the pull lever cannot return fully to the rest position the latch assembly will not operate. Make sure the open link tab fits into the open link slot. The 2010 honda cr v has 4 problems reported for door lock actuators failed. Remove the single screw in the middle of the gold plate taking care to note the position orientation of the small locking lever.