They go through the large screws which are used to adjust the door.
How to adjust framed glass shower doors.
They ride along a slanted adjustment slot that will raise and or lower the wheel.
How to adjust frameless glass shower door hinges.
Tighten the hinges that are attached to the wall.
To remove this type of guide just remove a single screw.
Loosen the screws holding the sliding wheels to the top of the door with a screwdriver until you can.
Make sure that the hinge itself is free of adhesives and caulk and use a little wd 40 on the join to help it move.
Many doors have a small plastic guide at the middle of the lower rail.
Open the door slightly and place wedges under it so the weight is supported.
You use an allen wrench in the tiny holes which is what we thought.
Remove the sliding glass door from the track by swinging the bottom toward the back of the shower and then lifting the door until the.
Others have a guide rail screwed to the door photo 1.
The clamps are usually tightened to the glass with phillips head screwdrivers.
Remove the screw and attach another wheel or.
Ask your assistant to hold the door fully open.
Position a 36 inch level vertically against the wall at the side of the enclosure where the door.
You can move the upper rollers so that the door is swinging a little higher in the gap and you can also fix the hinge to the shower door a little further down so that it flows freely.
Loosen the hex head bolts on each.
Replace the shower door and tighten the.
Loosen the top hinge and the bottom one if the glass is not snug against it.
The rollers are attached to the upper shower door with a screw.
Take this time to clean your screws with vinegar.
If an off track roller isn t the problem you ll have to remove the doors to adjust and possibly replace the rollers.
The door should now be fixed.
Loosen and remove the hinge screws that are attached to the door and remove the whole shower door.
Go inside the shower and ask your assistant to close the door.
Pharaoh posted in baths that it is a vienna hinge by crl.
None of the holes go all the way through.