If the top corner of your door is catching on the frame you ll need to adjust the hinges 1 x research source another step 2 tighten the screws on the door hinges with a screwdriver.
How to adjust closet door hinges.
You may need to add a second screw.
More is not better in this situation.
Next add a piece of wood shim or other hard material behindthe hinge.
Adjust the gap by bending the hinges open the hinge side gap by spreading the hinges.
Before i loosen the hinges where they are screwed into the cabinet i use a sharp pencil to mark the current.
Drive a screw near the middle of the area where the door is rubbing.
Otherwise turn the wrench counterclockwise to relieve tension from the hinge.
That s good all you will need to do is tighten them up.
I can widen the gap in small increments.
If you tightened the top hinge turn the bottom hinge clockwise by the same amount.
Tightening the door.
When this happens the top corner of the door catches on the door frame and prevents the door from closing properly.
How to adjust cabinet door hinges.
Step 1 examine the top corner of your door to see if it s catching on the frame.
To adjust cabinet doors left and right in the cabinet.
To adjust cabinet doors up and down.
Tighten screws gradually and watch the trim to make sure you don t.
This means that the hinge is only being supported by the door jamb itself not the framing lumber for the wall.
When the door is out of plumb it requires inserting a little amount of shim between the back of the hinge and the doorjamb which is usually the bottom hinge.
Each cabinet hinge has a large grub screw near the centre.
If the door has 3 hinges usually the ones on top and bottom are the only ones you need to adjust.
Over time the hinges on a door can loosen and cause the door to sag downward.
Drill through the jamb countersink the screwhead with a countersink bit.
First loosen the hinge screws most of the way.
I ve seen shims used behind the hinge leaf to adjust the gap but bending the hinge takes less time.
This prehung interior door repair could be that easy.