How To Adjust A Garage Door With 2 Large Sprins

Adjust the spring into the proper position and make sure your garage door closes all of the way.

How to adjust a garage door with 2 large sprins.

The torsion shaft powered by the spring lifts drums that easily winds cables connected with the doors at the bottom. This video applies t. There are two different types of spring systems for garage doors. Adjustments to these types of spring should only be done by a.

You must release the tension on the garage door springs before attempting adjustment or replacement. Garage door springs offset the weight of the door and allow it to open and close with ease. If your garage has only one entrance be sure you the assistant and the tools you need are inside before you lock the door. If it was opening too quickly move it to the next lower hole.

Your door will have either one or two torsion springs. Each torsion spring consists of spring coils stationary cone and a winding cone fig. If the door was closing too quickly move the spring to the next higher hole on the bracket. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments.

Retest the door balance as you did in step 1. The spring coils are color coded depending on the spring size and the. Adjust the springs on both sides of the door the same way. Please help support my channel so i can continue to make and provide the best possible video content for you to enjoy http www solwayplumbers co uk donate.

There are two torsion springs at each side of the garage door. Torsion springs are mounted directly above the door and need to be wound with special tools. The torsion spring helps the garage door open and close easily. One end of the spring is connected to the garage door track or frame.

The other is attached to a pulley connected to the cable. The whole garage door apparatus is very economically and smartly designed. The torsion springs and all the related apparatus are situated at the top of a garage door. This enables the opening and closing of the garage door.

Once the spring is free of tension remove from its track hanger. Detach the old spring from both ends and replace it with the new one and replace the pulleys as well if they are worn out. Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel. A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem.