How Do I Program A Genie Garage Door Remote

This small black unmarked button is located behind the light lens at the motor head and is nearest the floppy 6 inch antenna wire that protrudes from the motor head.

How do i program a genie garage door remote.

The led indicator will blink twice per second. Place the ladder under the garage door power head and climb so you are within reach of the control buttons. The power head is attached to the ceiling of your garage. Programming genie intellicode remote transmitters gently press and release the receiver learn code button on the power head receiver of your door operator.

Homelink programming would claim one of the available memories if desired. This will continue for about 30 seconds so continue quickly. Place the battery cover back on the remote control and press the white button on the remote control. Program the remote control press and release learn code button on the motor housing.

Up to seven remote operated devices can be programmed into one of the genie legacy intellicode garage door openers. How to program your genie garage door opener remote control. If the genie door opener does not operate one or more of the dip switches is not set correctly. Press and release the button on the remote you want to program.

Newer dc units can hold 28 remote. Step 2 press and hold the learn button on the side of the power head for approximately 10 seconds or until the indicator light turns off.